HOME | eAPPLICATION | CONTACT US | TECHNICAL SEARCH:             PRODUCTS | NEW PRODUCTS | ABOUT US | SUPPORT |

Getting a PTZ cam to work properly can be accomplished easily with the Tayama Software.

Just hook up the camera, hook it to a RS-232 Converter to a com port on the pc. Then pick the proper protocol or

if yours isn't on there, you can manually input the commands(taken from the manual or manufacturer)and add them to your

custom list of protocols.

For an in depth explanation of PTZ Setup click HERE

Here's the main Screen of the PTZ Control. You can get here by going to Setup, then clicking the Pan/Tilt tab at the top of the screen

If you have the PTZ cam, and you know which protocol it uses, check this list and see if it is in there.

If you cannot find the protocol to match your specific camera, or you know you will need to input a custom one.

This is where the user can input custom commands for their PTZ cams.

If you have a controller for your PTZ cam, this screen will be helpful.